1. From the gateway page, click Settings, 2. Click Manage Z-Wave Settings. 3. Enter Add Mode on the primary or inclusion controller (not the SysLINK gateway). 4. Click Enter Learn Mode on SysLINK. The gateway should add itself to the controller’s Z-Wave network.

1. Click the customize button on the upper right-hand corner of the mashup. 2. Click Select App. 3. Select the proper application. 4. As list of gateways appear on the Gateways mashup, click the Manage Gateways button. 5. In the lower left-hand corner, press the Factory Reset button. 6. Confirm the factory reset.

1. To add a device to the Z-Wave network, the following steps must be taken. From the gateway page, click Settings, 2. Click Manage Z-Wave Settings. 3. Click Add Device. Now that the gateway is looking for a device, the device must allow itself to be found. This process depends on the device. Some have a button, perhaps labeled “Add” or “Include” that you must press. Others enter the Add mode simply by inserting a battery or removing a plastic strip separating the battery from a contact. Consult the manufacturer’s documentation packaged with the device for details; instructions for many devices can be found on manufacturers’ websites. 4. After the device is connected, a configuration page appears. On this page you can assign a name to the device, assign the device to groups and specify whether to record device sensor history.

1. From the gateway page, click Settings, 2. Click Manage Z-Wave Settings. 3. Click Remove Device. Now that the gateway is looking for a device to remove, the device must allow itself to be found. This process depends on the device. Putting the device into remove mode may require pressing a button or removing a battery. Consult the manufacturer’s documentation packaged with the device for details; instructions for many devices can be found on manufacturers’ websites. When a device to remove is found, it appears in a list of deleted devices.