Hank
Smart Switch
HKZW-SW01
On/Off Power Switch
HW: 1 FW: 1.03
ZM5202
6.51.07
0x0208 (520)
0x0101 (257)
0x0003 (3)
ZC10-16085169
2016-08-15 05:55:48.4276
N/A
Enhanced 232 Slave
Always On Slave
Smart Switch is a Z-Wave Switch module specifically used to enable Z-Wave command and control (on/off) of any connected device such as bulbs.
21 - Setting device status after power failure
Define how the Smart Switch reacts after the power supply is back on.Size: 1 byte
Default: 0
Minimum: 0
Maximum: 0
Possible values
| From | To | Desription |
|---|---|---|
| 0 | 0 | Smart Switch memorizes its state after a power failure |
| 1 | 1 | Smart Switch will be on after the power supply is reconnected. |
| 2 | 2 | Smart Switch will be off after the power supply is reconnected. |
24 - Notification when Load status change
Smart Switch can send notifications to association device (Group Lifeline) when state of Smart Switch’s load is changed.Size: 1 byte
Default: 1
Minimum: 0
Maximum: 0
Possible values
| From | To | Desription |
|---|---|---|
| 0 | 0 | The function is disabled. |
| 1 | 1 | Send Basic report. |
| 2 | 2 | Send Basic report only when Load condition is not changed by Z-WAVE Command. |
27 - Indicator modes
After Smart Switch being included into a Z-Wave network, the LED in the device will indicator the state of load.Size: 1 byte
Default: 0
Minimum: 0
Maximum: 0
Possible values
| From | To | Desription |
|---|---|---|
| 0 | 0 | The LED will follow the status (on/off) of its load. |
| 1 | 1 | When the state of Smart Switch’s load changed, The LED will follow the status (on/off) of its load, but the red LED will turn off after 5 seconds if there is no more switch action. |
1) Connect the power supply. 2) Set the Z-Wave network main controller into learning mode (see Z-Wave network controller operating manual). 3) Triple click the Z-Button, LED indicator should blink fast。 4) Smart Switch should be recognized and included into the Z-Wave network.
1) Connect the power supply. 2) Set the Z-Wave network controller into the remove mode (see Z-Wave controller operating manual) 3) Triple click the Z-button.
1) Power on the Switch. 2) Press and hold the Z-button for more than 20 seconds. 3) If holding time more than one second, the LED will blink faster and faster. If holding time more than 20 seconds, the LED indicator will be on for 3 seconds, which indicates that the reset is complete, then it will blink slowly indicating that it is not a part of a Z-Wave network. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable.
| Type | Value(s) |
|---|