This performs the Z-Wave Set Learn Mode network operation. This can only be performed when Z-Ware is not in a network and will typically make Z-Ware an Inclusion or Secondary Controller, in which case, some of its facilities will not be available. To complete an S2 inclusion, the DSK may need to be entered on the including Controller. Note that this function may let camera works as ""secondary controller"" or ""inclusion controller"" in another existing network, just start inclusion mode or controller shift on another controller, then start camera learn mode, after inclusion, camera will replicate node information from another controller. Since our design is based on ""primary controller"", we recommend that you just use our camera as ""primary controller"".

This is the Z-Wave Set Default network operation and it pops up a confirmation prompt. If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.

Pressing the ""ADD NEW DEVICE"" button will let camera into inclusion mode 30 seconds. User can now trigger the device's node information frame to add to the camera's z-wave network. With Z-Wave Security 2, user needs to accept or modify the security class settings. It is recommended that the user not change the security class settings. Additionally for Security 2 Class 1 and 2 devices, the user needs to key in the 1st 5 digits of the DSK.

Pressing the ""REMOVE DEVICE button will let camera into exclusion mode 30 seconds. User can now trigger the device's node information frame to remove device from any z-wave network.