Learn Mode is used to receive network information from another controller (When including the eedomus controller on an existing network for example). To start the Learn Mode on the eedomus controller, click on : Configuration / Add or remove a device / Advanced Z-Wave function / Learn mode To include the eedomus controller on an existing network, start the inclusion process on the existing network controller (Refer to controller manual) then start learn mode on your eedomus controller.

You can proceed to a Z-Wave chip factory reset in order to do a fresh installation of your network. When doing that the Home ID of your network will change and your devices need to be excluded (In order to be reseted) and included again. To perform a factory reset, click on : Configuration / Add or remove a device / Advanced Z-Wave functions / Reset Z-Wave controller If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.

To add a Z-Wave device to the network, click on : Configuration / Add or remove a device / Add a Z-Wave device The eedomus controller will attempt to include the new node during 1 minute. Then press the button on the Z-Wave device to be added (Refer to device manual, activation of the inclusion may differ from device to device)

To remove a Z-Wave device from the network, click on : Configuration / Add or remove a device / Remove a Z-Wave device The eedomus controller will attempt to exclude the new node during 1 minute. Then press the button on the Z-Wave device to be removed (Refer to device manual, activation of the exclusion may differ from device to device)