Ecolink
Ecolink 700 Series Garage Door Controller
GDZW7-ECO
Motorized Barrier DT
HW: 01 FW: 01.00
ZGM130S037HGN2 / ZGM130S037HGN1
7.15.4
0x014A (330)
N/A
0x0007 (7)
ZC14-21120036
2021-12-09 08:34:03
N/A
Enhanced 232 Slave
Always On Slave
This is garage door controller allows users to wirelessly control and monitor their garage door. It monitors and reports the state of the garage door through use of a paired wireless (or wired) tilt sensor. It also determines when the garage door is active by utilizing an accelerometer to detect specific vibration patterns.
1. Follow the instructions of the Z-Wave controller to put the Z-Wave controller into manual or classic Z-Wave inclusion mode. 2. Locate and press the hub button on the device. 3. When it is successfully added, the device will beep and blink green once.
1. Follow the Z-Wave controller’s instructions on putting the Z-Wave controller into removal/exclusion mode. 2. Locate and press the hub button. 3. Device’s status indicator will blink red and beep three times to indicate successful removal.
Hold the reset button down for ten seconds. The status indicator will blink red while the reset button is pressed and will go out after ten seconds. The device’s status indicator will turn green when the reset operation is complete.
On the back of the device.
| Type | Value(s) |
|---|
| Group | Type |
|---|---|
| Access Control |
|
| System | Cover status: Tampering, product cover removed |