Z-Wave.Me
Z-Wave.Me mPCIe adaptor — Z-Wave™ & Zigbee/Thread mPCIe extension board
ZME_mPCIe_ZW_ZB
HARDWARE_DEVICE
HW: 3775531298 FW: 00.00
ZGM130S037HGN2 / ZGM130S037HGN1
7.19.2
N/A
N/A
N/A
ZC14-23080321
2023-08-28 10:52:38
N/A
Bridge Controller
N/A
Z-Wave.Me mPCIe adaptor — Z-Wave & Zigbee/Thread mPCIe extension board. Turns your embedded PC into a Z-Wave™ Smart Home Gateway. Comes with Z-Way software but can also run with third-party solutions that use Z-Wave Serial API.
Z-Wave.Me mPCIe adaptor — Z-Wave & Zigbee/Thread mPCIe extension board (front view with antennas connected)
Z-Wave.Me mPCIe adaptor — Z-Wave & Zigbee/Thread mPCIe extension board (back view)
Z-Wave Serial API SetDefault command is used to reset the RaZberry7 board to factory default settings. If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
| Type | Value(s) |
|---|