Z-Wave.Me
Z-Wave.Me Z-Station Z-Wave™ & Zigbee/Thread/Bluetooth Low Energy USB Adapter
ZME_ZSTATION_ZW_ZB
HARDWARE_DEVICE
HW: 8024121619 FW: 00.00
ZGM130S037HGN2 / ZGM130S037HGN1
7.19.2
N/A
N/A
N/A
ZC14-24020414
2024-02-29 15:41:32
N/A
Bridge Controller
N/A
Z-Wave.Me Z-Station — Z-Wave & Zigbee/Thread/Bluetooth Low Energy USB Adapter. Turns your PC into a Z-Wave® Smart Home Gateway. Comes with Z-Way software but can also run with third-party solutions that use Z-Wave Serial API.
Z-Wave.Me Z-Station Multi-Protocol USB dongle with Z-Wave & Zigbee/Thread/Matter/Bluetooth Low Energy
Z-Wave.Me Z-Station Multi-Protocol USB dongle with Z-Wave & Zigbee/Thread/Matter/Bluetooth Low Energy
Z-Wave.Me Z-Station Multi-Protocol USB dongle with Z-Wave & Zigbee/Thread/Matter/Bluetooth Low Energy
Z-Wave.Me Z-Station Multi-Protocol USB dongle with Z-Wave & Zigbee/Thread/Matter/Bluetooth Low Energy
Z-Wave Serial API SetDefault command is used to reset the RaZberry7 board to factory default settings. If this controller is the primary controller for your network, resetting it will result in the nodes in your network being orphaned and it will be necessary after the reset to exclude and re-include all of the nodes in the network. If this controller is being used as a secondary controller in the network, use this procedure to reset this controller only in the event that the network primary controller is missing or otherwise inoperable.
Built-in Zniffer and Network Diagnostics Tool
| Type | Value(s) |
|---|