Nice S.p.A
Dimmer-Control
FGD-212
Light Dimmer Switch
HW: 02 FW: 03.05:03.05
ZM5202AU-CME3
6.51.07
0x010F (271)
0x0102 (258)
0x2000 (8192)
ZC10-25070008
2025-07-01 08:52:31
N/A
Enhanced End Node 232
Always On Slave
This product allows dimming various types of lights from either a physical switch or by using the Z-Wave network.
To add the device to the Z-Wave network manually: 1. Place Dimmer-Control within the direct range of your Z-Wave hub. 2. Identify switch no. 1 (turns the light on) or the B-button (located on the device’s housing). 3. Set the main hub in (security/non-security) add mode (see the hub manual). 4. Quickly, three times press switch no. 1 or the B-button. 5. Wait for the adding process to end. 6. Successful adding will be confirmed by the Z-Wave hub message.
To remove the device from the Z-Wave network: 1. Place Dimmer-Control within the direct range of your Z-Wave hub. 2. Identify switch no. 1 (turns the light on) or the B-button (located on the device’s housing). 3. Set the main controller in remove mode (see the hub manual). 4. Quickly, three times press switch no. 1 or the B-button. 5. Wait for the removing process to end. 6. Successful removing will be confirmed by the Z-Wave hub message. 7. Dimmer-Control will start the calibration process.
Resetting Dimmer-Control 1. Disconnect the power supply. 2. Remove Dimmer-Control from the wall switch box. 3. Connect the power supply. 4. Locate the B-button on the housing. 5. Press and hold the B-button to enter the menu mode. 6. Wait for the visual LED indicator to turn yellow. 7. Quickly release and click the B-button again. 8. After few seconds the device is restarted, which is signalled with the red LED indicator color. 9. The device enters the calibration mode.